Toshiba Satellite 1400 Series Maintenance Manual page 178

3 Tests and Diagnostics
8. Configuration
This field displays the configuration method.
The devices are initialized when the PNP OS loads.
Setup by OS
All Devices
If you are using an OS that does not have PNP capacity, select "All Devices."
The Display shows the following message:
Device Config. = All Devices
9. I/O ports
This option controls settings for the parallel port.
NOTE: Do not assign the same interrupt request level and I/O address to the
serial port and PC card.
(a) Parallel
This option sets the interrupt request level (IRQ) and I/O port base address for
the parallel port. When the Printer Port Mode is set to Std. Bi-direct, the
options are:
LPT setting
LPT 1
LPT 2
LPT 3
Not Used
3-66
First, devices necessary for loading the OS will be
initialized. After the PNP OS loads, other devices will
be initialized by the OS. In this case, setup of PC Cards
will be fixed to "Auto-Selected," and cannot be
changed. (Default)
All devices will be initialized.
Interrupt level
7
5
7
Disables port
Satellite 1400/2400 Maintenance Manual (960-364/365)
I/O address
378H
278H
3BCH
3.23 SETUP