4 Replacement Procedures
3. Remove four M2.5×2.6 screws securing the metal case to the FDD and remove the
metal case.
4. Disconnect the FDD SUMI card from the connector of the FDD.
M2.5×2.6 screws
FDD SUMI card
NOTE: Two types of SUMI cards are used: one manufactured by TEAC and SAMSUNG
and one by MITSUMI.
Installing the FDD
To install the FDD, follow the steps below and refer to figures 4-26 and 4-27.
1. Connect the FDD SUMI card to the connector of the FDD.
2. Seat the metal case and secure it with four M2.5×2.6 screws.
3. Seat the FDD.
4. Connect the FDD SUMI card to PJ2007 on the system board.
4-44
FDD cable connector
Figure 4-27 Disassembling the FDD
Satellite1400/2400 Maintenance Manual (960-364/365)
FDD
Metal brace
M2.5×2.6 screws
Tape
4.10 FDD