AEQ DIGITAL COMMENTARY UNIT Customer's Manual page 86

Header line.
In the upper part of the screen operating zone, there is a header line which
displays the legend "Commentary Control Unit" , which identifies the type of
object being controlled by the screen, that is to say, a CCU.
Module Selector.
A 10 key selector, marked 1 to 10, can be found below the line identifier,
these correspond to the CONNECT TO MONITOR MODULE keys in each of
the line modules as described in section 3.4.2. of this manual.
When a key is " Clicked" with the mouse left button, the key appears to
collapse and is displayed in a clear grey color. This is the equivalent of the
illumination of a LED " selected module" as described in section 3.4.3. of this
manual. The CMs not present but included on the network structure will
appear in a disabled mode and can not be selected.
Alternately, when a key is pressed the " zoom +" shortcut becomes active
and allows selection of the Commentary Control Module screen, a second
press selects the associated Commentary Unit screen.
CCU Address.
The number identifying the position within the Commentary System Network
can be found in the CCU Address field, to the right of the module selector.
CU Status.
3 color CU status indicators are found beneath the module selector. As
described in section 3.4.2., they signal:
Red:
Orange:
Green:
Common signals.
This selector is a replica of that described in section 3.4.3. of this manual. It
permits the selection of the common signal (IS1, IS2, CUE1, CUE2 or PA)
that will be monitored via the intercommunicator associated with the control
PC position.
No CU connected
CU connected but reporting a transmission error
CU connected and operative
Digital Commentary System
-86-