AEQ DIGITAL COMMENTARY UNIT Customer's Manual page 40

for this CM from the MM, this having priority) as an alternative to the internal
OSC and ID signals. There are two program outputs, one through the multi-
connector to the IBC, and another labeled PGM AUX, this is situated at the rear
of the module and is available for local use. The output signal is monitored by
the individual VU-meter and passes to the monitor module where it can be
listened to, and measured with precision.
The STUDIO signal which enters the module with coordination circuits (CCGO)
destination, can be interrupted from the monitor module by the activation of
CCU intercommunication, CC TALK ON GO, (COORD GO) which has priority,
or through the internal signals OSC or ID in the AUDIO MODE selector. The
CC GO output goes through the multi-connector to the IBC. The output signal
passes to the monitor module where it can be listened to, and measured with
precision.
Each individual module receives the common signals (IS 1, IS 2, CUE 1, CUE
2, and PA) to send them to the CU.
The selection of the signal for listening, IS 1 or IS 2, is made at the module
input, the selected IS is sent to the CU as a reference for the earphone circuits
at the CU and passes to a dynamic audio processor (DLP). This processed
signal is mixed with the program if IS MIX ENABLE is open after being
regulated with MIX LEVEL potentiometer. A copy of the processed IS can be
sent to the monitor module (MM) to be controlled.
The Digital Level Processor characteristics are identical to the ones described
in paragraph 2.8. The DLP can only be configured from the Control Software ,
but it can be permanently stored in the control module for future use.
Route control of the passage (enable-disable) of CUE 1, CUE 2, PA, GUIDE
and AUX signal to the CU headphones is also performed. All these can be sent
to the monitor module in case they are required for monitoring. There is a
switch to perform the routing of CUE, Local T' B and Ringer to right, left or both
earphones of the commentators.
Various functions for each CU channel are managed from the CCU by remote
control : Together with the individual dynamic processor (DLP), a high pass
filter (HP FILTER) can be activated, access to the coordination circuit (CC F´B
ENABLE), and also the opening of the channel (CHANNEL ON), while
maintaining a parallel control of CHANNEL ON in the CU channel.
Digital Commentary System
-40-