AEQ DIGITAL COMMENTARY UNIT Customer's Manual page 80

This is the first section of the Network Setup window and is intended for the
configuration of the computer to network access parameters (see fig.
4.4.2.1.A). As the network is a serial bus structure, the first task is to configure
which of the computer' s serial ports is connected to the network and the
communications parameters to be used. The following parameters can be set:
• Port: Selection of the computer serial port to be used (COM1, COM2, COM3,
etc.).
• Baud rate: The communication speed in baud (not changeable).
• Data bits, Stop bits and Parity (not changeable).
• Enable long delay timeout: When the computer establishes communication
with network connected devices, it needs to send data and wait for the
response. If the communication conditions are degraded for any reason, the
user can increase the waiting time by enabling this option. This option is not
implemented yet.
Network map
fig. 4.4.2.1.B Network map screen
Digital Commentary System
-80-