AEQ DIGITAL COMMENTARY UNIT Customer's Manual page 64

3.4.3.2. MM :Lower section
Groups the elements
intercommunication, listening levels adjustment and headphone and ID input
connections.
INTERCOM
This refers to the communication of CCU technician with the program (PRG)
and coordination (CC) circuits.
Circuit selection. By this function, the technician connects with the PRG and
CC circuits of the selected module to communicate with them through his
headphone. This connection has higher priority than manual signals of PRG
and CC circuit that are interrupt while INTERCOM is active. A protection cover
is installed by cause of the consequences of using this intercommunication
while the programm is ON AIR.
• PRG: Connects program circuit (PRG) to technician headphone.
• CC: Connects coordination circuit (CC) to technician headphone.
• RESET. Disconnects previously established intercommunication circuit and
releases the PRG and CC circuits, standing this ones with its standard
signals.
• ROUTING selection. Once the circuit has been selected, allows to set the
communication direction.
• TALK ON GO: Technician communicates with IBC occupying the CCU
output lines.
PRG GO: Technician is in PRG circuit in GO direction, commentators output to
program and feedback to commentators are cut, on the monitor appears the
feedback that would enter to the CU and has been derived to intercom.
CC GO: Technician is in CC circuit in GO direction, commentators output to CC
and CC feedback to commentators are cut, on the monitor appears the
feedback that would enter to the CU and has been derived to intercom.
located under
Digital Commentary System
-64-
the loudspeaker, dedicated to