Power Supply Problems; Operating State Problems - Agilent Technologies SPS 4 User Manual

Power Supply Problems

If the Agilent SPS 4 appears to have no power and the power/error
indicator is not illuminated:
1 Check that the power cable is connected to the power supply and that
2 Visually check the Agilent SPS 4 and power lead for any electrical
3 If the Agilent SPS 4 still fails to initialize contact your Agilent customer

Operating State Problems

The power/error indicator is used to identify the operating state of the
Agilent SPS 4:
• If it is lit GREEN then the Autosampler has power. It is reasonable to
• If it is not lit, then turn off the power at the power switch on the rear
Agilent SPS 4 Autosampler User's Guide
it is turned on.
damage.
support representative.
assume that the autosampler is working correctly.
panel of the autosampler. Turn the power off at the power point. Check
that the power cable is correctly seated into the power supply. Check
the power plug from the power supply is inserted correctly into the
power supply inlet on the rear panel of the autosampler. Turn the
power on at the power point. Turn the power to the autosampler back
on at the power switch.
• If the autosampler initializes but the power/error indicator does not
illuminate then the indicator is potentially faulty. Contact your
authorized Agilent representative.
• If the autosampler does not initialize and the power/error indicator
does not illuminate then it is possible that either the power supply
or main board may be faulty. Contact your authorized Agilent
representative.
• If the autosampler does not complete initialization and the LEDs in
the power/error indicator are illuminated RED, the autosampler is in
an error state. Refer to the error codes in
Page 66 to identify the cause.
Troubleshooting
"Error Indicator Codes"
6
on
65