Installing Your Autosampler Cover - Agilent Technologies SPS 4 User Manual

A Appendices
1x Front Cover
Figure 21

Installing your Autosampler Cover

Fitting the Rear Cover
1 Remove the cable ducting that clips onto the rear of the end frame to
2 Remove the Spill Tray and the Rack Location Mat.
3 Lay the unit forward onto its front while supporting the probe arm.
84
1x Rear Cover
1x Duct Hose
1x Nut
Connection
Components in the autosampler cover kit
hold the power and communication cables in place.
1x Side Cover with a hole
1x Grommet
(fitted to rear cover)
1x Screw
Agilent SPS 4 Autosampler User's Guide
1x Side Cover (Blank)