Agilent Technologies SPS 4 User Manual page 43

6 Slip the tip of the sample probe into the hole in the middle of the
7 Slide the mount nut up onto the probe mount block and tighten to
8 Route the sample line from the sample probe to the left around the
Do not use the tube restraint for pre- formed sample probes. It is only
N O T E
used for non pre- formed sample probes.
Cable tie tubing through
the eyelet on bottom of
housing
Figure 14
Agilent SPS 4 Autosampler User's Guide
Z- axis slide, through the mount nut and the accessories plate until the
probe mount block is sitting in the z- axis slide.
secure the sample probe to the Z- axis slide.
probe arm housing. When using a carbon fiber sample probe, do not
run the sample line through the hook (or tube restraint) at the top of
the Z- axis slide. Connect the cable tie to the eyelet on the underside of
the probe arm cover and leave a loop of approximately 10 mm. Thread
the sample line through the loop in the cable tie as shown in
Colored Markers
Routing the sample line tubing
Tube Anchor
Installation 3
Figure 14.
Grommet
43