Installing The Wash Reservoir - Agilent Technologies SPS 4 User Manual

4 Position the rack location mat over the spill tray and align the dovetail
5 Check that the rack location mat fits firmly in place on the spill tray by
6 If the rack location mat does not fit correctly even after completing the

Installing the Wash Reservoir

Figure 8
The fixed wash reservoir is supplied as a kit with the inlet and outlet
nipples fitted along with some lengths of inlet (2.5 mm ID) tubing and
outlet (5.0 mm ID) tubing. For the single port fixed wash reservoir, rinse
solution flows up through the smaller wash chamber and overflows into
the larger drain chamber to waste. For the dual port fixed wash reservoir,
there are two wash chambers and a common drain chamber.
The fixed wash reservoir is mounted at the rear of the rack location mat
(see
To install the fixed wash reservoir:
1 Put the base of the fixed wash reservoir into the locating hole and twist
Agilent SPS 4 Autosampler User's Guide
feature in the mat with the dovetail feature in the left end frame before
pressing down firmly.
trying to move it from side to side and front to back. There should not
be any movement when fitted correctly.
steps above, contact your local Agilent office or representative.
Single port fixed wash reservoir and kit
Figure 6).
it clockwise 60 degrees so it locks into position. The nipples on the
fixed wash reservoir should be facing toward the rear of the
Installation 3
37