3
Installation
Installation Procedure
Carry out the assembly and test instructions as listed in the order below.
1
2
3
4
5
6
7
8
9
10
11
12
Position the autosampler so that it is easy to access the mains power switch on the
WA R N I N G
wall outlet or to remove the power cord from the autosampler or wall outlet.
Orientation
Any references to "Front", "Left", "Right" or "Rear", and 3 axes of
movement for the sample probe
(T- axis) and up and down (Z- axis) are as shown in
30
Inspection and Unpacking
Installing the Cover Kit
Fitting the Spill Tray
Installing the Rack Location Mat
Installing the Wash Reservoir
Installing the Standards Rack
Installing the Sample Racks
Fitting the Sample Probe
Fitting the Wash Pump Tubing
Connecting the Power and the Communications Cable
Confirming the Operation
Setting up the Instrument Controlling Software for SPS 4
—
longitudinal (X- axis), rotary or theta
Agilent SPS 4 Autosampler User's Guide
Figure
3.