Installing The Standards Rack - Agilent Technologies SPS 4 User Manual

For the materials of the rinse solution, see
Page 95.
Check the following points regularly:
N O T E
• There is no leakage between the main body and the connector of the
• The drain is not blocked by rinse and sample solution chemistry.

Installing the Standards Rack

Figure 10
The standards racks are located in the center of the rack location mat by
placing the rack's feet into the holes in the rack location mat. There are 2
standard rack options as shown in
the equipment depending on your application.
• 34 well rack (12 wells for 29 mm OD tubes + 22 wells for 17 mm OD
• 5 well rack (for 61 mm OD bottles)
To install the standards rack:
1 Locate the holes for the standards rack in the rack location mat.
2 Align the feet from the standards rack with the holes in the rack
Agilent SPS 4 Autosampler User's Guide
fixed wash reservoir.
Standards racks
tubes)
location mat. Press down on the rack to ensure it is correctly located
and the bottom of the standards rack is sitting flush with the rack
location mat.
"Default Rinse Materials"
Figure 10. Either may be supplied with
Installation 3
on
39