Agilent Technologies SPS 4 User Manual page 49

Application of the wrong supply voltage can create a fire hazard, or a potentially
WA R N I N G
serious shock hazard, and can seriously damage the instrument and any attached
ancillary equipment. Do not connect the instrument to the mains power until you
have ensured that the mains power supply from the outlets in your laboratory is
within the range stated in
The rear panel of the autosampler contains the peristaltic pump, purge
input, the power socket and switch, and a USB port for communication
between the autosampler and the computer that is running instrument
control software, as shown in
To connect the power:
1 Ensure that the power switch is turned off.
2 Connect the barrel output connector of the AC adapter to the power
3 Connect the input plug of the AC adapter to a suitable mains power
Ensure the autosampler is always connected to the protective grounding of
the mains supply.
Do not switch on the autosampler until all checks and settings for the
operation have been completed.
Host Communications Port (USB)
The host communications port (USB) is used to connect the autosampler
to the computer controlling your instrument.
To connect your autosampler:
1 Plug one end of the supplied USB cable into the host communications
2 Connect the other end of the USB cable to a USB port on your
3 Fix the USB cable and the power cable using the cable ducting on the
Agilent SPS 4 Autosampler User's Guide
supply input on the rear panel of the autosampler.
outlet.
port.
computer or instrument.
rear column of the autosampler.
on Page 22.
"Power"
Figure 2 on Page 19.
Installation 3
49