Table of Contents
Advertisement
Pump Module User Guide
Setup workflow
Setup workflow
Installing an autofilling reservoir or wash station
Auto Filling Reservoir, 96- or 384-Chimney Tip Wash Station, or Open Wash Reservoir
14
This topic describes the workflow for setting up an Agilent autofilling reservoir
or wash station on an Agilent liquid- handling device using the Pump Module.
Step
Procedure
1
Ensure that you are familiar with
the input and output ports for the
type of autofilling reservoir or
wash station.
2
If applicable, install the Weigh
Station or Weigh Shelf.
Note: Agilent Technologies installs
the Weigh Pad, if applicable.
3
Install the reservoir or wash
station.
4
Connect the Pump Module cables.
5
Route the tubing.
6
In the automation software,
configure the Pump Module,
reservoir, or wash station and
associated resources.
7
Weigh Station and wash stations.
Verify the teachpoint accuracy.
8
Verify the autofilling function of
the completed setup by performing
a pump fill and empty task using
the automation software.
To install the reservoir or Tip Wash Station:
1
Place the reservoir or wash station on the platepad or shelf at the desired
location on the liquid- handling device.
Note: For the Encore Multispan System, the reservoir is installed within
the pipettable area.
2
Using a 1.5- mm hex wrench, tighten the setscrew on the platepad tab or
shelf tab to secure the container.
See...
"Autofilling options" on page 9
•
Weigh Station. See
a Weigh Station" on page 25
•
Weigh Shelf. See the
Pipetting Station User
Guide.
"Installing an autofilling reservoir
or wash station" on page 14
"Connecting power and
communication" on page 15
"Routing the tubing" on page 17
User documentation for the
automation software at
www.agilent.com/chem/askb
User documentation for the
liquid- handling device at
www.agilent.com/chem/askb
User documentation for the
automation software at
www.agilent.com/chem/askb
Pump Module User Guide
"Installing
Vertical
Advertisement
Table of Contents
