5
Installing the UV-Visible Software
Installing the Agilent ChemStation Using the DVD
If the Security Pack had been installed, please see your manual Agilent ChemStation
N O T E
Security Pack for UV-Visible Spectroscopy - User's Guide for details.
During the installation some of your configuration files will be changed. If
you don't intend to use any ChemStation software you can remove the
ChemStation.ini file located in the operating system folder, C:\Windows by
default.
Installation Procedure
Use the following procedure if you are using the DVD to install or upgrade
the Agilent ChemStation.
Before installing the software:
• Set up the computer hardware.
• If GPIB communication will be used, connect as described in
• Make sure an operating system, supported by your revision of the
1 Insert the Agilent UV- Visible ChemStation Products DVD into the DVD
2 From the Start menu in the taskbar, select Start > Run.
3 At the command line, type diskdrive:\Setup.exe (for example, D:\
70
an GPIB Interface"
Agilent UV- Visible ChemStation software, is available on the target PC.
drive.
Setup.exe), then click OK.
Agilent Cary 8454 UV-Visible Spectroscopy System Installation Guide
on page 81 (not required for LAN communication).
"Installing