Installation Procedure Overview; Gpib Communications; Installing The Usb-Gpib Converter - Agilent Technologies 240 Series AA User Manual

Installation

Installation procedure overview

There are four software installation scenarios:
SpectrAA Base

SpectrAA PRO (or upgrade from Base to PRO)

SpectrAA Base to PRO upgrade

SpectrAA CFR

For installation instructions, refer to the appropriate instructions supplied with your
software:
SpectrAA Software installation instructions

SpectrAA Software Installation Instructions for 21 CFR Part 11 Environments


GPIB communications

A USB-GPIB converter must be installed in your computer to interface the
computer and the Agilent AA. See below for information on installing the USB-GPIB
converter.
Although the Agilent field service engineer will install the GPIB communications
NOTE
device for you during the installation process, you may need to configure the driver
yourself at some later stage, for example if you change the PC.

Installing the USB-GPIB converter

To install a National Instruments USB-GPIB converter:
NOTE
Ensure that the SpectrAA software has been installed.
1 Turn off the computer.
2 Connect one end of the converter to the instrument and the other end to the
USB connection on the back of the computer.
3 Turn on the computer.
38 Agilent 240/280 Series AA (including Zeeman)