Preparing The Cable For The Pull Cord Module - ASCOM teleCARE IP Installation Manual

Installation Guide
teleCARE IP
The four screws should be tightened carefully so that just enough pressure is applied on the gasket to
compress it evenly all around between the backplate and the wall surface.
Caution: Do not excessively tighten the fixing screws as this will distort the backplate and the
foam gasket resulting in an ineffective waterproof seal.

6.12.7 Preparing the Cable for the Pull Cord Module

After fixing the backplate to the back box, pull the cable through. It is important to ensure that a
minimum of 6in (15cm) of free cable is pulled out of the back box where teleCARE pull cord switch
module is to be installed.
17 July 2017 / Ver. PF3
Figure 117. Fixing the backplate to the wall
Figure 118. Preparing the cable for the pull cord module
TD 93021US
88