Corridor Lamp Housing; Nicl2 - Corridor Lamp Electrical Connections; Ip Room Controller Housing; Nicl2 - Corridor Lamp Pcb Component Side Electrical Connections - ASCOM teleCARE IP Installation Manual

Installation Guide
teleCARE IP
With the printed circuit board released from the holding clip, partly rotate the circuit board and remove it
from the housing.

5.8.3 Corridor Lamp Housing

The corridor lamp has the same housing as used for the IP room controller which is designed to be
surface mounted. Refer to section
the housing.

5.8.4 NICL2 - Corridor Lamp Electrical Connections

The wiring between NIRC3 and the NICL2 Corridor Lamp consists of the teleCARE IP four-wire room bus.
Figure 57. NICL2 - Corridor lamp PCB component side electrical connections
17 July 2017 / Ver. PF3
5.2.6, Room Controller Housing on page 23
Figure 56. IP room controller housing
Buzzer
Room Bus
(from the
Room Controller)
LED Lamp
Through-Board
Connectors
Input Connector
for Passive LED
mode
TD 93021US
for details of mounting
45