Box Sealing; Taping Heads Completion; Preliminary Electric Inspection; Main Power Machine Connection And Inspection - 3M Matic 7000r Instructions And Parts List

7. Installation

7.13 Box Sealing

1. Turn main air valve to "SUP" (On).
2. Release E-Stop Button. Press Reset Button.
Press Start Button. This process starts the
drive belts and pneumatic operations.
3. Feed boxes to machine allowing previous
box to exit machine BEFORE feeding next box.
4. Turn electrical/pneumatic switches "Off "
when machine is not in use.
5. Reload and thread tape as needed.
6. Be sure machine is cleaned and lubricated
according to recommendations in
"Maintenance" section of this manual.
7.14 Completion of Taping Heads
See Manual 2 for Complete Instructions:
1. Place the Upper Taping Head in a convenient
working position
2. Use Figure 7-18 and tape threading label.
Position the tape supply roll so the adhesive
side of tape is facing the front of the taping
head as it is pulled from the supply roll.
3. Thread tape over dancer arm roller (if dancer
arm used). Guide tape around tension wrap
roller (Position 1) then around one-way tension
roller (Position 2).
4. Pull it over knurled roller so adhesive side is
in contact with this roller (Position 3).
5. Pull tape down over tab adjustment roller.
Pull it under knurled roller and between
crescent tape guide and support pad
(Position 4) The tape should extend ½"/ 13mm
past the applying/compression roller).
6. Cut away excess tape and repeat steps for
Lower Taping Head.
Important – Do not cut against apply roller -

7.15 Preliminary Electric Inspection

Before connecting the machine to the mains
please carry out the following operations:
7.15.1 Make sure that the socket is provided with
an earth protection circuit and that both the
mains voltage and the frequency match the
specifi cations on the name plate.
7.15.2 Check that the connection of the machine to
mains meets the safety regulations in your country.
7.15.3 Refer to the Machine Name Plate and Specifi -
cations in this Manual to verify compatability
with the Electrical Mains on the machine.
3M-Matic 7000r-7000r3 HS Pro - Type 11800
™
Page 30
44-0009-2152-6 / ECO# 0078045
(continued)
roller damage could occur.
2
3
Figure 7-18
7.16 Machine Connection to the Mains
(For technical specifi cations:
See Section 4 - Specifi cations).
- Push the LATCHING EMERGENCY
STOP BUTTON.
- The main switch normally turned OFF.
Connect the power cord supplied to a wall
socket using a plug which complies with
safety regulations of your country.
Also refer to exploded
view Figure 3-4
Dancer
Arm Roller
(optional)
Tension
Wrap Roller
1
One-Way
Tension Roller
Tab Adjustment
Roller
Knurled /
Roller
Applying
Roller
4
North American - ENG
Date Released:
05-22-18