3M Matic 7000r Instructions And Parts List page 29

4. Specifi cations
Case Height Range Illustration:
A. Standard Machine Position: Outer Columns positioned against Stop with Upper Drive
B. Raised Machine Position:
Boxes narrower than 8" [200mm] may require more frequent belt replacement because of
limited contact area.
Special modifi cations may be available for carton sizes not listed on previous page.
Contact your 3M Representative for information.
Note: The case sealer can accommodate most boxes within the size range listed above.
3M-Matic 7000r-7000r3 HS Pro - Type 11800
™
Page 17
44-0009-2152-6 / ECO# 0078045
(continued)
Minimum/Maximum Box Height Combinations
(To relocate upper frame or outer columns, see "Special Set-Up Procedure")
Minimum / Maximum
88.9mm
[3 1/2"]
Operating
Range
Standard Machine Position:
Outer Column against Stop /
Upper Assembly - Lowest
Position on Inner Column
Note: Length of boxes in illustrations are not to scale.
However, if the box length (in direction of seal) to box height ratio is .6 or less,
then several boxes should be test run to assure proper machine performance.
Any box ratio approaching this limitation should be test run to assure performance.
DETERMINE THE BOX LIMITATIONS BY COMPLETING THIS FORMULA:
BOX LENGTH IN DIRECTION OF SEAL = SHOULD BE GREATER THAN .6
BOX HEIGHT
A
686mm
[27"]
Box
Box
Assembly set to Lowest Position on Inner Columns.
Tape Leg Length - 2" [50.8mm].
Maximum Box Height (i.e. Outer Columns and Upper Drive
Assembly in Highest Position - See Special Set-Up Procedure).
Tape Leg Length - 2" [50.8mm].
B
Minimum / Maximum
365mm 968mm
[14 3/8"] [38 1/8"]
Box
Operating
Range
Box
Outer Column:
Fully Raised
Position
North American - ENG
Date Released:
05-22-18