Cleaning - 3M Matic 7000r Instructions And Parts List

Maintenance

Cleaning

Regular slotted containers produce
a great deal of dust and paper chips
when conveyed through taping
heads. If this dust is allowed to
build-up on the heads, it can cause
wear on the moving parts.
Excessive dirt build-up should be
wiped off with a damp cloth.
Cleaning should be done once per
month, depending on the number
and type of boxes used. If the boxes
used are dirty, or if the environment
in which the heads operate is dusty,
cleaning on a more frequent basis
may be necessary.
Note – Never attempt to remove
Replacing Applying/Buffi ng Roller
1. Remove socket head cap screw.
2. Remove roller and wave washer.
3. Mount roller replacement.
4. Replace wave washer and socket
3M-Matic Accuglide 4 - 2 and 3 Inch Taping Head - Type 11800
™
Page 13
44-0009-2146-8 / ECO# 0078045
(continued)
dirt from taping heads by blowing
it out with compressed air.
This can cause the dirt to be
blown inside components and
onto sliding surfaces. Dirt in
these areas can cause serious
equipment damage.
Never wash down or subject
taping heads to conditions
causing moisture condensation
on components. Serious
equipment damage happen.
head cap screw.
Warning
• To reduce the risk associated with
shear, pinch, and entanglement hazards
- Turn air and electrical supplies off
on associated equipment before
performing any adjustments, mainte-
nance, or servicing the taping heads
- Never attempt to work on the taping
head or load tape while the box drive
system is running.
Warning
• To reduce the risk associated with
sharp blade hazards:
- Keep hands and fi ngers away from
tape cutoff blades under orange blade
guards. The blades are extremely sharp.
North American - ENG
Date Released:
05-22-18