Trouble Shooting - 3M Matic 7000r Instructions And Parts List

12. Operation
12.9 Trouble Shooting Guide (continued)
Problem
Upper Drive Assembly
comes down too fast/hard
or fails to operate
Centering Guides move
slower than normal or fail
to operate
Centering Guides don't
open 3 seconds after box
removed from machine
Machine Signals Case
Fault Jam after Guides
Fail to Open
Can't clear TAM Fault
Condition
Yellow Column Lights
Solid and Flashing
(also see TAM instructions)
3M-Matic 7000r-7000r3 HS Pro - Type 11800
™
Page 47
44-0009-2152-6 / ECO# 0078045
(continued)
Cause
Upper Drive Assembly Counter
Balance Regulator pressure set too
low
Defective Upper Drive Assembly
Counter Balance Regulator
Centering Guide Regulator
pressure set too low
Centering Guide Cylinder Speed
Controls need correct adjustment
Defective Centering Guide
Solenoid Valve/photo eye sensor
misaligned with sensor receptor
Centering Guide Photo Eye Sensor
"seeing" Guides as they close
Centering Guide Photo Eye Sensor
incorrect Height Setting
Sensor incorrect position
Sensor Failed
Absorption Pad damaged or missing
Low Tape (Solid Yellow)
Box Jam (Flashing Yellow)
Nose switch fault (Flashing Yellow)
Correction
Adjust Counter Balance Pressure
to increase pressure
Replace regulator
Adjust Centering Guide Regulator
Adjust Speed Controls mounted
on Centering Guide Cylinder
Replace Valve / Realign Photo
Eye Sensor and Sensor Receptacle
Adjust Height of Photo Eye Sensor
lower than Centering Guides
Adjust Closing Width of Centering
Guides (minimum closing width = 7.124")
Adjust Height of Photo Eye Sensor
lower than Centering Guides when
they are Completely Closed
Re-Position Sensor
Replace
Replace
Replace Tape
Remove jam
Press blue reset button and
restart machine
(continued on next page)
North American - ENG
Date Released:
05-22-18