Tape Leg Length; Electrical Connection And Controls; Initial Start-Up Of Case Sealer - 3M Matic 7000r Instructions And Parts List

7. Installation

7.9 Tape Leg Length

Taping heads are pre-set to apply
50.8mm [2 inch] long tape legs.
7.10 Electrical Connections and Controls

7.11 Initial Start-Up of Case Sealer

3M-Matic 7000r-7000r3 HS Pro - Type 11800
™
Page 26
44-0009-2152-6 / ECO# 0078045
(continued)
The electrical Push Button Station
"Start/Stop" with reset are located on
the left side of the machine frame
(Figure 7-11). If desired, for operator
convenience, this "Start/Stop" with
reset station can be relocated to
the right side of the machine frame.
A standard three conductor power
cord with plug is provided at the
back of the electrical control box for
electrical service (See Specifi cations).
The receptacle providing this service
shall be properly grounded. Before
the power cord is plugged into outlet
make sure that all packaging materials
and tools are removed from the machine.
Do not plug electrical cord into outlet
until ready to run machine.
Use of an extension cord is not recom-
mended. However, if one is needed for
temporary use, it must have a wire size
of 1.6mm diameter [AWG14], have a
maximum length of 7.5m [25 ft] and
must be properly grounded.
After completing the "Installation and
Set-Up" procedure, continue through
"Operation" for tape loading and
start-up to be sure case sealer is
properly adjusted to run boxes.
Warning
• To reduce the risk associated with
mechanical and electrical hazards:
- Read, understand, and follow all safety
and operating instructions before
operating or servicing the case sealer.
- Allow only properly trained and
qualifi ed personnel to operate and
service this equipment.
Warning
• To reduce the risk associated with
hazardous voltage:
- Position electrical cord away from foot
and vehicle traffi c.
Warning
• To reduce the risk associated with
pinches, entanglement and
hazardous voltage:
- Turn pneumatic and electrical supplies
off and disconnect before performing any
adjustments, maintenance or servicing
the machine or taping heads.
North American - ENG
Date Released:
05-22-18