3M Matic 7000r Instructions And Parts List page 20

3. Safety
(continued)
3.4 Operator's Qualifi cations
- Machine Operator
- Mechanical Maintenance Technician
- Electrical Maintenance Technician
- Manufacturer's Technician/Specialist
3.5 Number of Operators
The operations described below have
been analyzed by the manufacturer.
The recommended number of operators
for each operation provides the best
and safest work performance.
Note: A smaller or greater number of
3.6 Instructions for a Safe Use of the
Machine / Defi nition of Operator's
Qualifi cations
Only persons who have the skills
described in the skill levels section
should be allowed to work on the
machine. It is the responsibility of
the user to appoint the operators
having the appropriate skill level and
the appropriate training for each
category of job.
3.7 Residual Hazards
The case sealer 7000r-7000r3 HS Pro
incorporates various safety protections
which should never be removed or
disabled. It is essential that the operator
and service personnel be warned that
hazards exist which cannot be eliminated:
3.8 Recommendations and Measures to
Prevent Other Hazards which Cannot
be Eliminated
- The operator must stay on the
- The operator must pay attention
3M-Matic 7000r-7000r3 HS Pro - Type 11800
™
Page 8
44-0009-2152-6 / ECO# 0078045
(See Section 3)
operators could be unsafe.
working position shown in the
Operation Section. He must never
touch the running driving belts or
put his hands inside any cavity.
to the blades during the tape
replacement.
3.9 Personal Safety Measures
Safety glasses, safety gloves,
safety helmet, safety shoes,
air fi lters, ear muff s -
None are required except when
recommended by the user.
3.10 Predictable Actions which are
Incorrect and Not Allowed
- Never try to stop/hold the box
while being driven by the belts.
- Never remove or disable the
safety devices.
- Only authorized personnel should
be allowed to carry out the adjust-
ments, repairs or maintenance
which require operation with
reduced safety protections.
- During such operations, access to
the machine must be restricted.
When the work is fi nished, the
safety protections must immedi-
ately be reactivated.
- The cleaning and maintenance
operations must be performed
after disconnecting the pneumatic
system and electric power.
- Do not modify the machine or any
part of it.
- Clean the machine using only dry
cloths or light detergents. Do not
use solvents, petrols, etc.
- Install the machine following the
suggested layouts and drawings.
Warning
• To reduce the risk associated with
mechanical and electrical hazards:
- Read, understand, and follow all safety
and operating instructions before
operating or servicing the case sealer.
- Allow only properly trained and
qualifi ed personnel to operate and
service this equipment.
North American - ENG
Date Released:
05-22-18