Tape Leg Length - 3M Matic 7000r Instructions And Parts List

Adjustments
(continued)

Tape Leg Length

Trailing Tape Leg Length Adjustment –
Adjustment can range from 1¼" to 2 ¾" tabs.
The rear tab length can be adjusted by
removing the adjustment bar and placing
it along the two drill holes. The further
the bar extends from the cutting arm,
the longer the tab. The adjustment bar
can be removed entirely for minimum
tab length. Be sure the bar is fi rmly
reattached after adjusting (Figures 5-6).
Applying Leg Length
The front tab is adjusted by removing
adjustment roller and securing it in
one of fi ve position holes.
Be sure roller is fi rmly reattached
after adjusting (Figures 5-7).
Note – When changing tape leg length,
Note - Tab lengths are sensitive to
• To reduce the risk associated with
shear, pinch, and entanglement hazards
- Turn air and electrical supplies off
on associated equipment before
performing any adjustments, mainte-
nance, or servicing the taping heads.
- Never attempt to work on the taping
head or load tape while the box drive
system is running.
3M-Matic Accuglide 4 - 2 and 3 Inch Taping Head - Type 11800
™
Page 16
44-0009-2146-8 / ECO# 0078045
both upper and lower heads
must be adjusted to apply same
leg lengths.
tension levels. Generally,
lower tension settings are
required to create longer tabs.
Warning
Figure 5-6 Tape Leg Length
Figure 5-7 Changing Tape Leg Length
North American - ENG
Date Released:
05-22-18