Tape Loading - Lower Taping Head - 3M Matic 7000r Instructions And Parts List

Operation
(continued)
• To reduce the risk associated with
sharp blade hazards:
- Keep hands and fi ngers away from
tape cutoff blades under orange blade
guards. The blades are extremely sharp.
It is recommended that the detailed
instructions and sketches in this manual
be referred to the fi rst few times the
taping head is loaded/threaded until the
operator becomes thoroughly familiar
with the tape loading operation.
Note: If practical, remove tape roll before
Note: Threading can usually be accomplished
Tape Loading – Upper Taping Head
1. Place the upper taping head in a
convenient working position.
2. Using Figures 3-2/3-3/3-4/3-5 and 3-6.
Position tape roll so adhesive side of
tape faces front of taping head as it's
pulled from supply roll.
3. Thread tape over dancer arm roller
(if dancer arm used).
Guide tape around tension wrap roller
(Position 1) then around one-way
tension roller (Position 2).
4. Pull it over knurled roller so
adhesive side is in contact with
this roller (Position 3).
5. Pull tape down over tab adjustment
roller. Pull it under knurled roller and
between crescent tape guide and
support pad (Position 4) The tape
should extend ½" - 13mm) past the
applying/compression roller).
6. Cut away any excess tape.
Important – Do not cut against apply roller -
Tape Loading – Lower Taping Head
See upper head instructions.
3M-Matic Accuglide 4 - 2 and 3 Inch Taping Head - Type 11800
™
Page 10
44-0009-2146-8 / ECO# 0078045
Warning
removing taping head from
machine to minimize weight.
without removing the tape applicator
from the case sealer, due to the open
design. Arrow shaped stickers along
the rollers should direct threading of tape.
roller damage could occur.
Warning
• To reduce the risk associated with
shear, pinch, and entanglement hazards
- Turn air and electrical supplies off
on associated equipment before
performing any adjustments, mainte-
nance, or servicing the taping heads
- Never attempt to work on the taping
head or load tape while the box drive
system is running
Caution
• To reduce the risk associated with
muscle strain:
- Use proper body mechanics when
removing or installing taping heads
that are moderately heavy or may be
considered awkward to lift
• To reduce the risk associated with
impact hazards
- Place the taping head on a smooth
level surface when maintaining or
servicing this equipment
Figure 3-3: Insert threading needle through
rollers in direction indicated by arrows.
1
2
3
4
Figure 3-2 Tape Loading/Threading
Also refer to exploded
view Figure 3-4
Dancer
Arm Roller
(optional)
Tension
Wrap Roller
One-Way
Tension Roller
Tab Adjustment
Roller
Knurled /
Roller
Applying
Roller
North American - ENG
Date Released:
05-22-18