Box Sealing; Outboard Tape Roll Holder; Preliminary Electric Inspection - 3M -Matic 7000r Instructions And Parts List

7-INSTALLATION AND SET-UP (continued)

7.18 Box Sealing

1. Turn main air valve to "SUP" (On).
2. Turn pneumatic/electrical switch on side of
machine frame to start machine.
3. Press Push Button Station "Start/Stop" to start
drive belts and Air Pressure/Pneumatic operations.
4. Feed boxes to machine allowing previous box to
exit machine BEFORE feeding next box.
5. Turn air and electrical/pneumatic switch "Off"
when machine is not in use.
6. Reload and thread tape as necessary.
7. Be sure machine is cleaned and lubricated
according to recommendations in "Maintenance"
section of this manual.
7.19 Completion of Taping Heads
See Manual 2 or 3 for Complete Instructions:
1. Place the Upper Taping Head in a convenient
working position
2. Use Figure 7-21 and tape threading label.
Position the tape supply roll so the adhesive
side of tape is facing the front of the taping head
as it is pulled from the supply roll.
3. Attach the threading needle to the end of the
roll. Guide the threading needle around the wrap
roller (Position 1) then back around the one-
way tension roller (Position 2).
4. Continue pulling the threading needle down and
guide it between the two (2) rollers on the apply
arm (Position 3).
5. Pull the threading needle down until the tape
travels between the apply plate and the ears of
the apply arm (Position 4) until it extends past
the applying roller. When properly threaded the
adhesive side of the tape should be facing the
knurled rollers at position 2 and also position 3.
6. Cut away any excess tape and repeat steps for
Lower Taping Head.
Important – Do not cut against the apply roller -
roller damage could occur.

7.20 Outboard Tape Roll Holder

To use the Outboard Tape Roll Holder:
1 - Remove the lower taping head from the machine.
2 - Remove the tape drum bracket assembly, stud
spacer, and fasteners from the lower taping head.
3 - Install alternative wrap roller and bracket on the
head in place of tape bracket. Replace lower
head into machine.
4 - Install and secure tape drum bracket assembly on the
entry end of the lower frame (as shown in Figure 7-22.
7000r-7000r3 Pro - NA
#2
Figure 7-21
Figure 7-22

7.21 Preliminary Electric Inspection

Before connecting the machine to the mains please
carry out the following operations:
7.21.1 Make sure that the socket is provided with
an earth protection circuit and that both the
mains voltage and the frequency match the
specifi cations on the name plate.
7.21.2 Check that the connection of the machine
to the mains meets the safety regulations in
your country.
7.21.3 The machine is fi tted with a main switch
and a circuit breaker. The user should check
that the electrical settings of the machine are
compatible with all the components of the
mains system.
7.22 Machine Connection to the Mains
For technical specifi cations: See Section 4 -
Specifications
- Push the LATCHING EMERGENCY STOP BUTTON.
- The main switch is normally turned OFF.
Connect the power cord supplied with the machine to a
wall socket using a plug which complies with the safety
regulations of your country.
31
One Way
Tension
Roller
Tension
#1
Wrap
Roller
Knurled
Roller
Wrap
#3
Roller
Applying
Roller
Threading
Needle
#4
2014 June