Infeed Conveyor Assembly; Centering Guides - 3M Matic 7000r Instructions And Parts List

7. Installation

7.7 Infeed Conveyor Assembly

1. Remove the conveyor and the
2. Verify that package contains two (2)
3. To assemble the infeed conveyor,
4. Insert a M8 × 15 screw in each
5. Attach the infeed conveyor over the
6. Refer to Figure 7-9. Set the cover

7.8 Centering Guides

1. Remove the two centering guides
2. Using a 5mm hex key wrench,
3M-Matic 7000r-7000r3 HS Pro - Type 11800
™
Page 25
44-0009-2152-6 / ECO# 0078045
(continued)
package of parts from the carton.
right angled cover plates, twelve (12)
M8 × 15 hex head screws, and
eight (8) M8 fl at washers.
refer to Figure 7-8 and locate
four (4) bolt holes on the infeed
end of the case sealer frame.
hole so that only a few threads
take hold. Do not use washers
with these screws.
screws using the inverted keyholes
in the end of the conveyor.
Tighten all four (4) screws with a
13mm wrench.
plates over the joint between the
conveyor and the frame on each
side and secure them with four (4)
M8 × 15 screws and M8 washers.
and four (4) M6 × 20 socket head
screws from the package.
attach the centering guides to the
rails with four (4) M6 × 20 screws
(two [2] in each guide) as shown in
Figure 7-10.
Figure 7-8 Infeed Conveyor
Figure 7-9 Cover Plates
Figure 7-10 Centering Guides
North American - ENG
Date Released:
05-22-18