Table of Contents
Advertisement
11 - OPERATION (continued)
Figure 11-13
If the box is hard to move under the top head or is
crushed, raise the top head slightly.
If the box movement is jerky or stops under the top
head, move the side drive belts in slightly to add
more pressure between the box and drive belts.
Note: Upper head has unique feature for
overstuffed boxes. The head will raise
up to 13mm [1/2 inch] to compensate for
this type of condition.
CAUTION – If drive belts are allowed to slip
on box, excessive belt wear will occur.
11.4 Box Sealing
•
To reduce the risk associated with pinches and entanglement hazards:
−
Do not leave the machine running while unattended.
−
Turn the machine off when not in use.
−
Never attempt to work on any part of the machine, load tape, or remove jammed boxes from the
machine while the machine is running.
1. Connect electrical and air supplies.
2. Turn main air valve "On" and adjust air regulator if pressure does not read 5 bar gauge pressure [70 PSIG].
3. Press electrical "On" button to start drive belts.
4. Continually feed boxes to case sealer, case sealer will automatically space entrance of boxes to machine.
5. Turn electrical and air supplies "Off" when machine is not in use.
6. Reload and thread tape as necessary.
7. Be sure machine is cleaned and lubricated according to recommendations in "Maintenance" section of this
manual.
Notes:
1. Box drive motors are designed to run at a moderate temperature of 40° C [104° F]. In some cases they
may feel hot to the touch.
2. Adjustment of the machine or taping heads are described in the "Adjustment" section of this manual.
800af-I-NA
Figure 11-13 – Box Size Set-Up
WARNING
34
2010 December
Advertisement
Table of Contents
