Table of Contents
Advertisement
7. Installation
7.18 Box Sealing
1. Turn main air valve to "SUP" (On).
2. Turn pneumatic/electrical switch
3. Press Push Button Station "Start/
4. Feed boxes to machine allowing
5. Turn electrical/pneumatic switch
6. Reload and thread tape as needed.
7. Be sure machine is cleaned and
7.19 Completion of Taping Heads
See Manual 2 or 3 for Complete
Instructions:
1. Place the Upper Taping Head in
2. Use Figure 7-22 and tape threading
3. Attach the threading needle to the
4. Continue pulling the threading
5. Pull threading needle down until
6. Cut away excess tape and repeat
Important – Do not cut against apply
7.20 Outboard Tape Roll Holder
To use the Outboard Tape Roll Holder:
1 - Remove lower taping head from
3M-Matic
7000r-I / 7000r3-I Pro - Type 11700
™
Page 31
44-0009-2165-8 / ECO# 0078045
(continued)
(side of machine) to start machine.
Stop" to start drive belts and Air
Pressure/Pneumatic operations.
previous box to exit machine
BEFORE feeding next box.
"Off" when machine is not in use.
lubricated according to recom-
mendations in "Maintenance"
section of this manual.
a convenient working position.
label. Position the tape supply roll
so the adhesive side of tape is
facing the front of the taping head
as it is pulled from the supply roll.
end of the roll. Guide the threading
needle around the wrap roller
(Position 1) then back around the
one-way tension roller (Position 2).
needle down and guide between
the two (2) rollers on the apply arm
(Position 3).
the tape travels between apply
plate and the ears of the apply arm
(Position 4) until it extends past the
applying roller. When properly
threaded the adhesive side of the
tape should be facing the knurled
rollers at position 2 and position 3.
steps for Lower Taping Head.
roller - roller damage could occur.
machine.
Source Document for all related Manuals/Translations
#2
#3
#4
Figure 7-22
Figure 7-23
2 - Remove tape drum bracket assembly, stud
spacer, fasteners from lower taping head.
3 - Install alternative wrap roller and bracket
on head in place of tape bracket.
Place lower head in machine.
4 - Install and secure tape drum bracket
assembly on the entry end of lower frame
(as shown in Figure 7-23).
7.21 Preliminary Electric Inspection
Before connecting the machine to the mains
please carry out the following operations:
7.21.1
Make sure that the socket is provided
with
an earth protection circuit and that both the
mains voltage and the frequency match
the specifications on the name plate.
7.21.2
Check that connection of machine to
mains
tions in your country.
7.21.3
The machine is fitted with a main
switch and
circuit breaker. The user should check that
electrical settings of machine are compatible
with all the components of the mains system.
7.22 Machine Connection to the Mains
This machine may be recieved without an
electrical plug. Select a plug suitable for your
existing electrical service and compliant with
local electrial codes. Connect the Line, Neutral,
and Ground (Protective Earth) wires of the
machine to the appropriate terminals of the
plug following plug manufacturers instructions
Original Instructions
One Way
Tension Roller
#1
Tension
Wrap Roller
Knurled Roller
Wrap Roller
Applying Roller
Threading Needle
meets safety regula-
International - ENG
February 2021
Advertisement
Chapters
Table of Contents
