Box Sealing; Taping Heads Completion; Outboard Tape Roll Holder; Preliminary Electric Inspection - 3M 7000R Instructions And Parts List

7. Installation

7.18 Box Sealing

7.19 Completion of Taping Heads

7.20 Outboard Tape Roll Holder

3M-Matic 7000r-7000r3 Pro
™
Page 31
(continued)
1. Turn main air valve to "SUP" (On).
2. Turn pneumatic/electrical switch
(side of machine) to start machine.
3. Press Push Button Station "Start/
Stop" to start drive belts and Air
Pressure/Pneumatic operations.
4. Feed boxes to machine allowing
previous box to exit machine
BEFORE feeding next box.
5. Turn electrical/pneumatic switch
"Off " when machine is not in use.
6. Reload and thread tape as needed.
7. Be sure machine is cleaned and
lubricated according to recom-
mendations in "Maintenance"
section of this manual.
See Manual 2 or 3 for Complete
Instructions:
1. Place the Upper Taping Head in
a convenient working position
2. Use Figure 7-22 and tape threading
label. Position the tape supply roll
so the adhesive side of tape is
facing the front of the taping head
as it is pulled from the supply roll.
3. Attach the threading needle to the
end of the roll. Guide the threading
needle around the wrap roller
(Position 1) then back around the
one-way tension roller (Position 2).
4. Continue pulling the threading
needle down and guide between
the two (2) rollers on the apply arm
(Position 3).
5. Pull threading needle down until
the tape travels between apply
plate and the ears of the apply arm
(Position 4) until it extends past the
applying roller. When properly
threaded the adhesive side of the
tape should be facing the knurled
rollers at position 2 and position 3.
6. Cut away excess tape and repeat
steps for Lower Taping Head.
Important – Do not cut against apply
roller - roller damage could occur.
To use the Outboard Tape Roll Holder:
1 - Remove lower taping head from
machine.
#2
#1
#3
#4
Figure 7-22
Figure 7-23
2 - Remove tape drum bracket assembly, stud
spacer, fasteners from lower taping head.
3 - Install alternative wrap roller and bracket
on head in place of tape bracket.
Place lower head in machine.
4 - Install and secure tape drum bracket
assembly on the entry end of lower frame
(as shown in Figure 7-23.

7.21 Preliminary Electric Inspection

Before connecting the machine to the mains
please carry out the following operations:
7.21.1 Make sure that the socket is provided with
an earth protection circuit and that both the
mains voltage and the frequency match the
specifi cations on the name plate.
7.21.2 Check that the connection of the machine
to the mains meets the safety regulations in
your country.
7.21.3 The machine is fi tted with a main switch and
circuit breaker. User should check that elec-
trical settings of the machine are compatible
with all components of mains system.
7.22 Machine Connection to the Mains
For technical specifi cations:
See Section 4 - Specifi cations
- Push the LATCHING EMERGENCY
STOP BUTTON.
- The main switch normally turned OFF.
Connect the power cord supplied to a wall
socket using a plug which complies with
safety regulations of your country.
One Way
Tension Roller
Tension
Wrap Roller
Knurled Roller
Wrap Roller
Applying Roller
Threading Needle
NA - ENG
April 2016