3M Matic 7000r Instructions And Parts List page 64

13. Maintenance and Repairs
Refer to Figure 13-5 and 13-6 and
adjust belt tension as follows:
1. Remove and retain center plates/
2. Loosen, but do not remove, the
3. Reset the tension on the drive belts
4. Replace center plates/front cover
Drive
Belts
3M-Matic 7000r-7000r3 HS Pro - Type 11800
™
Page 52
44-0009-2152-6 / ECO# 0078045
front cover and four (4) screws.
lock nut with an open end wrench.
as needed. Adjust the tension
screws in (clockwise) to increase
tension or out (counterclockwise)
to decrease tension. Tighten lock
nut to secure tension setting.
and secure with original screws.
Center
Flat Head
Plate
Screws (4)
Lock
Nut
Hex
Wrench
Figure 13-5 Box Drive Belt Tension Adjustment, Lower Belts (Infeed End)
(continued)
• To reduce the risk associated with
- Turn pneumatic and electrical supply
Socket Hd
Tension
Adjustment
Screw
Warning
pinches, entanglement and
hazardous voltage:
off and disconnect before performing
any adjustments, maintenance or
servicing the machine or taping heads.
North American - ENG
Infeed End
Date Released:
05-22-18