Run Boxes - Inspect Adjustment; Tape Application Monitor Adjustments (Optional) - 3M Matic 7000r Instructions And Parts List

11. Set-Up and Adjustments
11.5 Run Boxes to Inspect Adjustment
(Figures 11-4 and 11-5)
Important: Before starting machine,
Release E-Stop (if engaged), Press
Reset Button, and then press Push
Button Station "Start" (Figure 11-4).
This starts the drive belts and
engages the pneumatic air pressure
system. Move box forward on the
infeed conveyor until the Box
Centering Photo Sensor is activated
(which activates the Box Centering
Side Guides and automatically
centers the box - Figure 11-5).
Continue moving the box forward
until it contacts the Upper Drive
Assembly Raise Switch (Figure 11-5).
The Upper Drive Height adjustment
adjusts automatically as the box is
forwarded by the drive belts under
the Upper Drive Assembly.
Note: Always push at the end of
Important – If drive belts are allowed
Note - For belt replacement and
11.6 Tape Application Monitor (TAM)
Adjustments (Optional)
TAM Sensor Positioning adjustments can
be "fi ne tuned" to help meet needed
production requirements.
3M-Matic 7000r-7000r3 HS Pro - Type 11800
™
Page 43
44-0009-2152-6 / ECO# 0078045
(continued)
check to be sure no tools or other
objects are on the conveyor bed.
the box. If the box is not
centered correctly or the
Upper Drive Assembly does
not contact the top of the
box correctly, see pressure
adjustment settings and/or
the Troubleshooting Section.
to slip on box, excessive
belt wear will occur.
tension specifi cations -
refer to Section 13 /
Maintenance and Repairs.
Reset
Button
"On/Off "
Button
Air Valve
"On/Off "
Main Gauge
Air Pressure
Upper Drive
Box Raising
Switch
Box
Direction
Warning
• To reduce the risk associated with
pinch and entanglement hazards:
- Keep hands clear of the upper head
support assembly as boxes are
transported through the machine.
- Keep hands, hair, loose clothing, and
jewelry away from box compression
rollers and all moving parts.
- Always feed boxes into the machine
by pushing only from the end of box.
Warning
• To reduce the risk associated with
pinches, entanglement and
hazardous voltage:
- Turn pneumatic and electrical supply
off and disconnect before performing
any adjustments, maintenance or
servicing the machine or taping heads.
Figure 11-4
Figure 11-5
Centering
Side Guides
Box Centering
Photo Sensor
(under guard)
North American - ENG
Date Released:
05-22-18