Safety Devices; Blade Guards; Emergency Stop Button; Electric System / Circuit Breaker - 3M Matic 7000r Instructions And Parts List

10. Safety Devices of the Machine

10.1 Blade Guards

Both the top and bottom taping
units have a blade guard
(See Manual 2: AccuGlide™ 4
Taping Heads - 2" or 3").

10.2 Emergency Stop Button

The box drive belts are turned on and
off with the electric "Start/Stop"
button on the side of the machine
frame (Figure 10-2).
- To restart machine, rotate the
- Then Press Reset Button
- Then press the Station "Start"

10.3 Electric System / Circuit Breaker

The electric system is protected by
a ground wire whose continuity has
been tested during fi nal inspection.
The system is also subject to insula-
tion and dielectric strength tests.
Note: The case sealer has a circuit
Important: The use of an extension
3M-Matic 7000r-7000r3 HS Pro - Type 11800
™
Page 41
44-0009-2152-6 / ECO# 0078045
emergency stop switch clockwise
to release the switch latch
(Figure 10-1).
(Figure 10-2).
Button (Figure 10-2) .
breaker located in the electrical
enclosure on the machine frame.
If circuit becomes overloaded
and circuit breaker trips, unplug
the machine electrical cord.
1. Determine cause of overload
and correct.
2. Plug in machine.
3. Turn/Release E-Stop Button.
4. Press Reset and then "On" (I)
Button to resume case sealing.
cord is not recommended.
However, if one is needed
for temporary use, it must:
• Have a wire size of 1.6mm
diameter [AWG 14]
• Have a maximum length of
7.5m [25 ft]
• Be properly grounded.
E-Stop
Figure 10-1
"Start-Stop"
and Reset
Buttons
Start
Stop
Figure 10-2
Warning
• To reduce the risk associated with
hazardous voltage:
− Position electrical cord away from foot
and vehicle traffi c.
Warning
• To reduce the risk associated with
mechanical and electrical hazards:
− Allow only properly trained and qualifi ed
personnel to operate and service this
equipment.
Reset
North American - ENG
Date Released:
05-22-18