Maintenance; Tools; Blade Replacement - 3M Matic 7000r Instructions And Parts List

Maintenance

The AccuGlide™ 4 High Performance 2 and
3 Inch Taping Head has been designed
for long, trouble free service. The taping
head will perform best when it receives
routine maintenance and cleaning.
Taping head components that fail or
wear excessively should be promptly
repaired or replaced to prevent damage
to other portions of the head or product.

Tools

Metric Hex Keys - Ball end set recommended.
2mm, 2.5mm, 3mm, 4mm, 5mm, and 6mm.
Wrenches - 8mm, 10mm, 5/18 inch, 15/16 inch.
Thread Lock Compound/Fasteners -
Critical fasteners may be secured with
thread locking compound. To loosen
and remove a diffi cult fastener, apply heat.

Blade Replacement

Upper and Lower Taping Heads – Figure 4-1
1. Remove Blade Screw (position 1).
2. Remove blade cover plate and blade
(position 2).
3. Replace blade and cover plate.
4. Reinsert and tighten screw.
Note – Check the blade position
Blade Guard
The blade guard covers the blade
whenever a box is not being taped.
Periodically check to be sure the
blade guard is functioning properly
and returning to cover the blade.
Replace any defective parts.
Blade Grease Pad
To reduce adhesive build-up, the taping
heads are equipped with a factory pre-
lubricated felt grease pad that provides
a fi lm of grease on the cutting edge of
the blade. Blade maintenance should
include keeping felt pad saturated with
grease. Should tape adhesive build-up
occur on blade, carefully wipe clean with
light solvent or grease soaked cloth.
3M-Matic Accuglide 4 - 2 and 3 Inch Taping Head - Type 11800
™
Page 12
44-0009-2146-8 / ECO# 0078045
to insure proper clearance
between blade and guard by
slowly pivoting blade guard back.
Warning
• To reduce the risk associated with
shear, pinch, and entanglement hazards
- Turn air and electrical supplies off
on associated equipment before
performing any adjustments, mainte-
nance, or servicing the taping heads
- Never attempt to work on the taping
head or load tape while the box drive
system is running
Knife
Holder
3
Figure 4-1 Blade Replacement
Warning
• To reduce the risk associated with
sharp blade hazards:
- Keep hands and fi ngers away from
tape cutoff blades under orange blade
guards. The blades are extremely sharp.
(maintenance continued on next page.)
Knife
Guard
1
2
North American - ENG
Date Released:
05-22-18