Cover Power Plate; Cover Power Plate Removal Procedure; Cover Power Plate Replacement - Qualstar RLS-8350 Technical & Service Manual

7.9 Cover Power Plate

P/N 510687-01-5
Tools Required:
No. 2 Phillips Screwdriver
•
A Cover Power Plate must be installed in any power supply opening on an RLS that is
not occupied by a power supply. Please contact Qualstar Technical Support if addi-
tional Cover Power Plates are required.
Figure 7-7 Cover Power Plate shown on rear of RLS

7.9.1 Cover Power Plate Removal Procedure

Use a No. 2 Phillips screwdriver to remove the screw that secures the Cover
1.
Power Plate to the rear of the RLS.

7.9.2 Cover Power Plate Replacement

This procedure assumes that the Carriage Assembly was removed in Section 7.9.1.
Place the Cover Power Plate into the power supply opening with the tabs as
1.
shown in Figure 7-7.
Use a No. 2 Phillips screwdriver to replace and tighten the screw that secures
2.
the Cover Power Plate to the rear of the RLS.
511010 Rev. 07-01-19
Screw
Field–Replaceable Units (FRUs)
Cover
Power
Plate
7-11