Qualstar RLS-8350 Technical & Service Manual page 92

The front hand holds must be removed from the library before it can be slid all
16.
the way back into the rack. Use a Number 2 Phillips screwdriver to remove the
two screws that secure the hand holds to the left and right sides of the RLS.
Figure 7-24 Removing the Front Hand Holds from the Library
Store the front hand holds and their mounting screws in a safe location so they
17.
may be re-used if the library is removed from the rack.
With the hand holds removed, slide the library all the way back into the rack
18.
until the flanges on the sides touch the front rack posts.
Figure 7-25 The Library fully inserted into the Rack
7-28
Remove the
2 Screws
Install one screw in each rack
post to secure the library to the
rack.
Field–Replaceable Units (FRUs)
Front
Hand Hold
Flange
511010 Rev. 07-01-19