Subject
SCSI Architecture Model-2 (SAM-2)
SCSI-3 Primary Commands (SPC)
SCSI-3 Primary Commands - 2 (SPC-2)
SCSI-3 Primary Commands - 3 (SPC-3)
SCSI-3 Media Changer Commands (SMC)
Automation/Drive Interface – Transport Protocol (ADI)
Automation/Drive Interface - Commands (ADI)
Table 1-1 Applicable Documents
Although Qualstar has made every effort to insure the accuracy of the information
contained in this manual, no guarantee is expressed or implied that the manual is
error-free. Qualstar reserves the right to make changes at any time without prior no-
tification.
The Qualstar RLS is a sophisticated, state-of-the-art computer peripheral. It may on-
ly be serviced by an authorized service technician who is experienced with the opera-
tion and maintenance of tape libraries, and only after reading and understanding this
manual and the RLS Installation and Operation Manual.
1.2 Important Safety Information
All of the operating instructions and maintenance procedures in Qualstar manuals
must be followed to prevent personal injury or damage to the equipment. In the inter-
ests of safety, there are two kinds of warnings used in Qualstar documents, as shown
below.
PERSONAL INJURY MAY RESULT IF YOU DO NOT FULLY COMPLY WITH THE
HANDLING, OPERATING, OR SERVICE INSTRUCTIONS FOUND IN A DANGER
PARAGRAPH.
1-2
Document
ANSI INCITS 366-2003
ANSI X3.301-1997
ANSI INCITS 351-2001
ANSI INCITS 408-2005
ANSI INCITS 314-1998 [R2003]
ANSI INCITS 406-2005
ANSI INCITS 403-2005
DANGER
Introduction
Qualstar
Documen
t
Number
N/A
N/A
N/A
N/A
N/A
N/A
N/A
511010 Rev. 07-01-19