Replacing A Storage Matrix Assembly Blank - Qualstar RLS-8350 Technical & Service Manual

Two large tabs at the top and bottom of the Storage Matrix Assembly Blank
4.
have a single captive screw in each of them that secures it to the RLS. Figure 7-4
shows a view of the tab at the bottom of the RLS. A flashlight and/or a small
mirror may be helpful to see the exact location of the two screws.
Figure 7-4 Captive screw shown securing the bottom tab of the Storage Matrix Assembly
Blank
Reaching into the RLS through the left side storage matrix opening, engage the
5.
two captive screw fasteners and turn them counter clockwise until they are fully
loosened. If the screws can be reached, skip to step 10, otherwise follow the next
step to remove the face of the user interface panel assembly.
Once both screws from the Storage Matrix Assembly Blank are loosened, careful-
6.
ly pull it off the RLS and set it aside.

7.6.2 Replacing a Storage Matrix Assembly Blank

This procedure assumes that the Carriage Assembly was removed in Section 7.6.1.
Align the guide pin on the right side of the Storage Matrix Assembly Blank with
1.
the corresponding hole on the right side of the library, then position it against
the front of the RLS. See Figure 7-3.
Reaching into the library, engage the two captive screw fasteners and turn them
2.
clockwise until they are fully tightened to secure the blank to the RLS.
Replace the left side storage matrix as described in Section 7.5.2.
3.
511010 Rev. 07-01-19
Captive screw used to secure the top and bottom tabs.
Field–Replaceable Units (FRUs)
Storage Matrix
Assembly
Blank
7-7