Qualstar RLS-8350 Technical & Service Manual page 77

Reach into the RLS to the right side of the Carriage Assembly and carefully dis-
3.
connect the System connector from the 10U Z Satellite PCBA.
Figure 7-9 10U Z Satellite PCBA with the System Connector
There are only two screws on the front of the Carriage Assembly that secure it to
4.
the RLS. Use a No. 2 Phillips screwdriver to remove the both screws. They are
the lower and larger pair as shown in Figure 7-10.
Figure 7-10 The Carriage Assembly Screws
With the screws removed, simply slide the Carriage Assembly out of the RLS.
5.
511010 Rev. 07-01-19
Remove these 2 Screws
Field–Replaceable Units (FRUs)
Disconnect the
System Connector
The 10 Z Satellite PCBA
7-13