Replacing A Storage Matrix - Qualstar RLS-8350 Technical & Service Manual

Carefully slide the matrix out from the front of the RLS until it stops.
4.
There is a handle built into the top of the storage matrix that must be turned 90
5.
degrees so it is pointing up. When this handle is in the up position the matrix is
ready to be completely removed from the library.
Folded up for removal.
Figure 7-2 Storage Matrix Top Handle
A storage matrix may be heavy when loaded with tapes and caution should
be taken to securely grasp the top handle when removing it or inserting it in-
to the library. Tilting the storage matrix when it is outside the library may
cause tapes to fall from the storage slots and become damaged.
While securely grasping the top handle of the storage matrix and using your
6.
other hand to guide it, slide the matrix out of the library.
Place the storage matrix on a stable surface.
7.

7.5.2 Replacing a Storage Matrix

Power may remain on when performing this procedure.
1.
While securely grasping the top handle of the storage matrix and using your
2.
other hand to guide it, align the matrix with its slots in the library.
Carefully slide it in until the handle on top of the matrix makes contact with the
3.
library.
511010 Rev. 07-01-19
CAUTION
Field–Replaceable Units (FRUs)
Folded down for replacement.
7-5