5.2.4 Z Corrections Screen
Figure 5-9 The Calibration/Z Corrections Screen
This screen shows the value of the mechanical position corrections determined during
calibration to adjust for mechanical manufacturing tolerances.
Information on this screen may be edited by pressing the Edit button. Note that
changes to the screen will not be saved until the Save button is pressed. Pressing the
Cancel button will remove all of the current editing.
Section
Z – IO Port Corrections
Z – Drive Corrections
Z – Left Corrections
Z – Right Corrections
Table 5-4 Calibration/Z Corrections Screen Information
511010 Rev. 07-01-19
Field
Left IO Port
Calibrated mechanical position corrections
Right IO Port
Calibrated mechanical position corrections
Drive 1
Calibrated mechanical position corrections
Drive 2
Calibrated mechanical position corrections
Drive 3
Calibrated mechanical position corrections
Drive 4
Calibrated mechanical position corrections
Drive 5
Calibrated mechanical position corrections
Drive 6
Calibrated mechanical position corrections
Drive 7
Calibrated mechanical position corrections
Column A
Calibrated mechanical position corrections
Column B
Calibrated mechanical position corrections
Column C
Calibrated mechanical position corrections
Column D
Calibrated mechanical position corrections
Column A
Calibrated mechanical position corrections
Column B
Calibrated mechanical position corrections
Column C
Calibrated mechanical position corrections
Column D
Calibrated mechanical position corrections
The Private
Description
Option
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
5-9