Cleaning The Sprayer Valves - Toro MultiPro 1750 Operator's Manual

Cleaning the Sprayer
Valves
•
To clean the rate-control valve, refer to the
following sections:
1. Removing the Valve Actuator (page 62)
2. Removing the Rate-Control-Manifold Valve
(page 63)
3. Cleaning the Manifold Valve (page 66)
4. Assembling the Manifold Valve (page 67)
5. Installing the Rate Control Manifold Valve
(page 68)
6. Installing the Valve Actuator (page 71)
•
To clean the agitation valve; refer to the following
sections:
1. Removing the Valve Actuator (page 62)
2. Removing the Agitation-Manifold Valve
(page 63)
3. Cleaning the Manifold Valve (page 66)
4. Assembling the Manifold Valve (page 67)
5. Installing the Agitation-Manifold Valve (page
68)
6. Installing the Valve Actuator (page 71)
•
To clean the master-section valve, refer to the
following sections:
1. Removing the Valve Actuator (page 62)
2. Removing the Master-Section-Manifold
Valve (page 64)
3. Cleaning the Manifold Valve (page 66)
4. Assembling the Manifold Valve (page 67)
5. Installing the Master-Section-Manifold Valve
(page 69)
6. Installing the Valve Actuator (page 71)
•
To clean the 3 section valves; refer to the following
sections:
1. Removing the Valve Actuator (page 62)
2. Removing the Section-Manifold Valve (page
65)
3. Cleaning the Manifold Valve (page 66)
4. Assembling the Manifold Valve (page 67)
5. Installing the Section Manifold Valve (page
70)
6. Installing the Valve Actuator (page 71)
Removing the Valve Actuator
1. Position the sprayer on a level surface, engage
the parking brake, shut off the pump, shut off the
engine, and remove the key.
2. Remove the 3-pin connector of the valve
actuator from the 3-socket connector of the
sprayer harness.
3. Remove the retainer that secures the actuator to
the manifold valve for the rate control, agitation,
master section, or section valve
Note:
Squeeze the 2 legs of the retainer
together while pushing it down.
Note:
Retain the actuator and retainer for
installation in Installing the Valve Actuator (page
71).
Section-Valve Actuator Shown (the agitation-valve actuator
1. Valve actuator (section
valve shown)
2. Retainer
4. Remove the actuator from the manifold valve.
62
(Figure
Figure 66
is similar)
3. Stem port
66).
g028237