Cleaning The Sprayer Valves - Toro Multi Pro WM 41240 Operator's Manual

Cleaning the Sprayer
Valves
•
To clean the rate control valve, refer to the
following sections:
1. Removing the Valve Actuator (page 66)
2. Removing the Rate Control Manifold Valve
(page 67)
3. Cleaning the Manifold Valve (page 70)
4. Assembling the Manifold Valve (page 71)
5. Installing the Rate Control Manifold Valve
(page 72)
6. Installing the Valve Actuator (page 75)
•
To clean the agitation valve; refer to the following
sections:
1. Removing the Valve Actuator (page 66)
2. Removing the Agitation Manifold Valve
(page 67)
3. Cleaning the Manifold Valve (page 70)
4. Assembling the Manifold Valve (page 71)
5. Installing the Agitation Manifold Valve (page
72)
6. Installing the Valve Actuator (page 75)
•
To clean the master boom valve, refer to the
following sections:
1. Removing the Valve Actuator (page 66)
2. Removing the Master Boom Manifold Valve
(page 68)
3. Cleaning the Manifold Valve (page 70)
4. Assembling the Manifold Valve (page 71)
5. Installing the Master Boom Manifold Valve
(page 73)
6. Installing the Valve Actuator (page 75)
•
To clean the 3 section valves; refer to the following
sections:
1. Removing the Valve Actuator (page 66)
2. Removing the Section Manifold Valve (page
69)
3. Cleaning the Manifold Valve (page 70)
4. Assembling the Manifold Valve (page 71)
5. Installing the Section Manifold Valve (page
74)
6. Installing the Valve Actuator (page 75)
Removing the Valve Actuator
1. Position the sprayer on a level surface, set the
parking brake, stop the pump, stop the engine,
and remove the key from the switch.
STARTER
66
2. Remove the 3-pin connector of the valve
actuator from the 3 socket electrical connector
of the sprayer harness.
3. Remove the retainer that secures the a actuator
to the manifold valve for the rate control,
agitation, master boom, or boom section valve
(Figure 87).
Note:
Squeeze the 2 legs of the retainer
together while pushing it down.
Note:
Retain the actuator and retainer for
installation in Installing the Valve Actuator (page
75).
Figure 87
Section Valve Actuator shown (the agitation valve actuator
is similar)
1. Valve actuator (section
valve shown)
2. Retainer
4. Remove the actuator from the manifold valve.
g028237
3. Stem port