Selecting A Nozzle; Cleaning The Sprayer System - Toro Multi Pro 5800-D Operator's Manual

3. Remove the clogged nozzle and clean it using a
spray bottle of water and a toothbrush.
4. Install the nozzle.

Selecting a Nozzle

Note:
Refer to the nozzle-selection guide that is
available through your Authorized Toro Dealer.
The turret bodies can accept up to 3 different nozzles.
To select the desired nozzle perform the following:
1. Stop the sprayer on a level surface, shut off the
engine, and engage the parking brake.
2. Set the master section switch to the O
and set the spray-pump switch to the O
position.
3. Rotate the turret of the nozzles in either direction
to the correct nozzle.
4. For machines operated in the application rate
mode, perform a flow calibration; refer to the
Software Guide for the Multi Pro 5800-D and
5800-G turf sprayers with ExcelaRate spray
system.
Cleaning the Sprayer
System
Draining the Tank
1. Stop the sprayer, engage the parking brake, and
shut off the engine.
2. Locate the tank-drain valve at the left, rear
fender of the machine
Note:
The drain valve is attached to the
drain-valve bracket that is mounted to the left,
rear fender.
Figure 37
1. Drain valve (sprayer tank)
3. Lift the valve until the mount studs of the valve
clear the slots in the drain-valve bracket, and
move the valve rearward
position
FF
FF
(Figure 37).
g191084
(Figure 38A).
1. Drain-valve bracket
2. Mount studs (drain valve)
4. Align the end of the valve with the drain
container and rotate valve handle to the open
position (Figure
5. When the tank has drained completely, rotate
the drain-valve handle to the closed position and
assemble the valve onto the drain-valve bracket
(Figure 38B and
Important:
Dispose of the sprayer tank
chemicals according to local codes and the
material manufacturer's instructions.
Cleaning the Sprayer
Important:
You must always empty and clean
the sprayer and any installed spray accessories
immediately after each use. Failure to do so may
cause the chemicals to dry or thicken in the lines,
clogging the pump and other components.
Toro recommends using the approved Clean Rinse Kit
for this machine. Contact your Authorized Toro Dealer
for more information.
Clean the spray system and any installed spray
accessories after each spraying session. To properly
clean the spray system:
•
Use 3 separate rinses.
37
Figure 38
3. Drain valve handle (open
position)
38B).
Figure 38A).
g191083