Removing An I C Multiplexer Card - IBM x iDataPlex dx340 Series Problem Determination And Service Manual

2
Removing an I C multiplexer card
To remove a multiplexer card from the I/O enclosure, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the system-board tray is installed in a chassis, remove it (see "Removing the
3. Remove the I/O enclosure from the system-board tray (see "Removing an
4. Carefully set the I/O enclosure on a flat, static-protective surface.
5. Make a note of where the cables are attached to the I
6. Remove the screws that secure the I
7. Pull the I
8. If you are instructed to return the I
104
System x iDataPlex dx340 Types 6385, 6386, 6389, 7831, 7832, and 7834: Problem Determination and Service Guide
on page 71.
system-board tray from a 2U chassis" on page 75).
expansion enclosure from a system-board tray" on page 73).
disconnect them.
and save them for future use.
2
C multiplexer card from the mounting clips and remove the card from
the I/O enclosure.
instructions, and use any packaging materials for shipping that are supplied to
you.
2
C multiplexer card; then,
2
C multiplexer card to the I/O enclosure
2
C multiplexer card, follow all packaging