Installing a 2.5-inch hot-swap hard disk drive
To install a 2.5-inch hot-swap hard disk drive, complete the following steps.
1. Touch the static-protective package that contains the hard disk drive to any
unpainted metal surface on the outside of the chassis or rack; then, remove the
hard disk drive from the package.
Attention:
Do not press on the top of the drive. Pressing the top might
damage the drive.
2. Make sure that the drive tray handle is in the open position.
3. Align the drive with the guide rails in the drive bay; then, carefully slide the drive
into the bay until the drive stops.
4. Rotate the drive tray handle to the closed position.
Chapter 4. Removing and replacing server components
89