Installing The System-Board Tray - IBM x iDataPlex dx340 Series Problem Determination And Service Manual

Installing the system-board tray

To install a system-board tray, complete the following steps.
Note: You might have to remove component fillers or covers before you can install
some components.
1. Reinstall the microprocessors and heat sinks (see "Installing a microprocessor
and heat sink" on page 143).
2. Reinstall the DIMMs (see "Installing a memory module" on page 107).
3. Reinstall the battery (see "Installing the battery" on page 86).
4. Reinstall the riser card (see "Installing a PCIe riser-card assembly in the
system-board tray" on page 116).
5. Reinstall the PCIe adapters, if you removed any (see "Installing an adapter in
the system-board tray" on page 101).
Chapter 4. Removing and replacing server components
153