Installing The System-Board Tray Cover - IBM x iDataPlex dx340 Series Problem Determination And Service Manual

Installing the system-board tray cover

To install the system-board tray cover, complete the following steps.
Attention:
is installed and closed or an expansion enclosure is installed. Do not attempt to
override this protection.
1. Lower the cover so that the pins at the rear of the cover slide down into the
2. Pivot the cover to the closed position until it clicks into place.
3. Install the system-board tray in the chassis (see "Installing the system-board
122
System x iDataPlex dx340 Types 6385, 6386, 6389, 7831, 7832, and 7834: Problem Determination and Service Guide
You cannot insert the system-board tray into a chassis until the cover
System-board
tray cover
slots at the rear of the system-board tray. Before you close the cover, make
sure that all components are installed and seated correctly, all internal cables
are correctly routed, and you have not left loose tools or parts inside the
system-board tray.
tray in a 2U chassis" on page 76 or "Installing the system-board tray in a 3U
chassis" on page 78).
System-board
tray