Installing The Pcie Adapter Bay Cover - IBM x iDataPlex dx340 Series Problem Determination And Service Manual

Installing the PCIe adapter bay cover

To install the PCIe adapter bay cover on the I/O enclosure, complete the following
steps.
I/O enclosure
1. Make sure that no wires are protruding and might interfere with the cover.
2. Orient the PCIe adapter bay cover so that the retention tabs in the cover align
3. Slide the PCIe adapter bay cover into the tab slots in the I/O enclosure.
4. Install the two retaining screws.
5. Install the I/O enclosure on the system-board tray (see "Installing an expansion
6. Install the system-board tray in the chassis (see "Installing the system-board
114
System x iDataPlex dx340 Types 6385, 6386, 6389, 7831, 7832, and 7834: Problem Determination and Service Guide
PCI slots
PCIe bay cover
with the tab slots in the enclosure.
enclosure on a system-board tray" on page 74).
tray in a 2U chassis" on page 76 or "Installing the system-board tray in a 3U
chassis" on page 78).
Slot cover
Tabs
End of
Bay cover
Adapter
Screws